WET610N is a dual-band Wireless Ethernet Bridge on an IEEE 802.11n draft 2.0 are based and optimized for video transmission. WET610N can either 2.4 GHz or 5.0 GHz frequency band to operate (selectable dual band), and it is fully backward compatible with 802.11a/b/g infrastructure, widespread, 1-port 10/100 Mbps half or full duplex mode, auto-sensing, integrated QoS features.
The IP address is set to DHCP, if you have a router or DHCP server, check the DHCP client table address have. If there is no DHCP server is detected, the bridge to the IP address 169.254.1.250 default.
WET610N not over standard IP address. He catches up with the router or DHCP server.
You should know the wireless settings of your network. How to check the wireless settings of the router.
How do I set WET610N:
Connect to the router WET610N with the Ethernet cable.
Open the setup page of your wireless router and go to the DHCP client table list. This list shows the devices connected to your network. You can find the IP address of the bridge. Write down this number.
Open the Internet browser and in the address bar the IP address of the bridge. This opens the Setup page of the bridge.
Click the Wireless tab and go to Wireless Network Site Survey. Select your wireless network from the list and try to connect. When itis a secure wireless network, enter the password of your wireless network. It will connect to the network.
Now unplug the Ethernet cable from the bridge and turn it. Try pinging the IP address of the now WET610N.
If you are found not in a position to bridge your IP address in the DHCP client table of the router, then you can try another way to enter Setup.
Connect your WET610N to the Ethernet port on your computer. Press and hold the reset button for 30 seconds. Release the reset button and wait 30 seconds. Turn it.
Now, open the Internet browser on your computer and in the bat-type169.254.1.250 address. Log on to the setup page and try to connect to the wireless network.
Once the wireless bridge is successfully configured, you can get it on the device you use to connect to the network. You can use them with special devices such as Playstation, Xbox or Sony bdp s590 3D too. If you have more that one device that you want to use it, you can wirelessly connect the bridge to a switch and connect all devices to the switch. This way you can connect multiple devices to the wireless network with just a wireless bridge.